Troubleshooting guide

Synology Backup Destination Full: Diagnose Before You Delete

Category: Backup & Restore

Troubleshooting

Your offsite Hyper Backup task halts at the destination-full step, and you want to confirm the cause before deleting anything. ## Check the destination free space and quota First, open Hyper Backup on the source NAS and review the task log for the exact error. Then log in to the destination NAS or remote server and check available space on the shared folder that hosts the vault. If the folder has a quota, compare used space against the quota limit, not just the volume total. A folder quota can report full while the volume still has room. ## Review retention and version settings In Hyper Backup, open the task settings and inspect the rotation schedule. If retention keeps too many versions or the schedule creates versions faster than the destination can hold, the vault fills predictably. Note the number of retained versions and the size of the latest backup. If the destination free space is smaller than one full backup plus the retained versions, the task cannot complete. ## Run a verification test After freeing space or adjusting retention, run a small test: create a temporary shared folder with a few files, add it to a new test task pointing at the same destination, and run it once. If it completes, the destination has usable space and the original task should proceed. If it fails with the same error, the quota or volume is still constrained. ## Rollback and recovery note Before deleting old versions, export the task configuration and confirm you have a recent restore point. If you remove versions and the task still fails, restore the previous retention settings and recheck the destination. For a controlled diagnosis of a synology backup destination full condition,

A Synology backup task and a restored sample folder

Ask for help.


Back to the service page · Ask about this exact symptom