Troubleshooting guide

Synology Backup Task Stopped: Diagnose a Full Offsite Destination

Category: Backup & Restore

Your offsite Hyper Backup task stops at the destination-full step, and you want to confirm whether the vault is truly out of space before changing anything.

Check the destination’s actual free space

On the remote Synology NAS that hosts the vault, open Storage Manager and note the volume’s free space and the shared folder quota for the vault. A volume can show free space while the vault’s shared folder quota is exhausted. If the quota is at or near its limit, that is your immediate cause. If both volume and quota show ample space, the stop may be a stale size calculation; continue below.

Review retention and version size

In Hyper Backup on the source NAS, open the task and inspect its retention settings. Smart Recycle or a high number of versions can retain large blocks the destination cannot reclaim. Check the vault’s reported size against the volume’s capacity. If retained versions exceed available space, the task will stop again even after a restart.

Run a verification test

Temporarily disable the schedule, then run the task manually once. If it stops at the same step, the space condition is confirmed. Next, open the vault in Hyper Backup Explorer and confirm the latest backup set is readable. This proves existing data is intact before you modify retention or storage.

Recover safely

Before deleting versions, export the task configuration. If you reduce retention, keep at least one recent version and verify the next run completes. If the destination volume is genuinely full, add capacity or move the vault to a larger volume, then re-link the task. A synology backup task stopped event caused by space will recur until capacity or retention changes.

If these checks do not isolate the cause,

A Synology backup task and a restored sample folder

Ask for help.


Back to the service page · Ask about this exact symptom