Troubleshooting guide

Synology Hyper Backup Index Corrupted: Diagnose and Recover

Category: Backup & Restore

You are running an integrity check on your offsite Hyper Backup vault, and it stops with a damaged index or incomplete backup message, leaving you unsure whether the backup is usable or how to proceed safely.

Confirm the Failure Scope

First, reproduce the check from Hyper Backup > Backup Explorer or the task’s Integrity Check option. Note the exact error text and the timestamp. A message naming a specific index file (for example, a .idx or database file) points to index corruption. A message about an incomplete backup usually means the last version did not finish writing. If the check passes on a second run without changes, treat the first result as a transient read error and monitor it.

Isolate the Cause

Check the remote vault’s free space and the NAS system log for I/O errors or unexpected disconnects during the last backup window. Verify the network path to the offsite destination is stable. Then open Backup Explorer and confirm whether earlier versions are listed and browsable. If older versions open but the latest does not, the index for the newest version is the likely culprit.

Verification Test

Restore a single small file from the most recent version that opens successfully to a temporary shared folder. If the restore completes and the file opens, the vault’s data is intact and only the latest index entry is damaged. If the restore fails, stop and preserve the vault before any further writes.

Recovery and Rollback

Do not delete the vault. If a prior version restores correctly, you can roll back the backup task to that version and let the next run rebuild forward. For a synology hyper backup index corrupted state where no version opens, keep the vault untouched and seek guided recovery before reinitializing.

A Synology backup task and a restored sample folder

Ask for help to plan the next step without risking the offsite copy.


Back to the service page · Ask about this exact symptom