Troubleshooting guide

Offsite Hyper Backup Restore Completes but Expected Files Are Missing: A Controlled Diagnosis

Category: Backup & Restore

You restored from your offsite Hyper Backup vault, the job finished without errors, yet files you know exist in the backup are absent from the target share.

Confirm which version and scope you actually restored

Open Hyper Backup, select the vault, and choose Restore. Before starting, note the version timestamp and whether you restored a full share or selected folders. A common cause of a synology hyper backup restore missing files result is restoring an older version than the one containing the files. Compare the version date against when the files were last modified. If the files were created after that timestamp, they are not in that version. Restore the newest version instead.

Check filters and folder selection

In the restore wizard, expand the folder tree. Confirm the parent folder is checked, not just a child. Verify no restore filter (file type or size) is active. If you restored to a new shared folder, confirm the destination path matches the original structure; nested folders can appear empty if the parent was skipped.

Inspect the backup index

Run Backup Integrity Check on the vault from Hyper Backup. If it reports a damaged index or incomplete backup, the catalog may not list all files even though data blocks exist. Do not delete the vault; preserve it for recovery.

Verification test

Restore a single known file from the same version to a temporary folder. If it appears, the version is intact and your earlier scope was wrong. If it does not, the index is suspect.

Rollback note

Keep the original restore target until verification passes. If the test fails, restore again from the newest version to a fresh folder rather than overwriting.

If the index check fails,

A Synology backup task and a restored sample folder

Ask for help before making changes.


Back to the service page · Ask about this exact symptom