Troubleshooting guide
Synology Hyper Backup Vault Password Rejected: Diagnose the Encryption Key Error
Category: Backup & Restore
You are restoring from an offsite Hyper Backup vault, the vault opens, but the encryption key or password is rejected before you can proceed.
Confirm the exact credential being requested
First, distinguish the vault password from the encryption key. In Hyper Backup, the remote vault may require the vault password to open, then the encryption key to decrypt. If the vault opens but the key is rejected, the issue is likely the encryption key, not the vault password. Check the restore wizard label carefully. If it says encryption key, do not re-enter the vault password. If it says password, verify the vault password separately.
Check for input and version mismatches
Re-enter the key manually, not pasted, and confirm there are no trailing spaces. Verify the key file matches the backup job by checking the job name and creation date in Hyper Backup. If the vault was created by a different NAS or DSM version, confirm the key was exported from that same job. A key from another job will be rejected even if the password looks correct. Also confirm the restore is using the correct Hyper Backup version for the vault format.
Verification test
Create a small test restore from the same vault to a local folder. If the key is accepted there, the remote vault is fine and the issue is in the remote restore path. If it is rejected locally too, the key or password is wrong for this vault.
Rollback and recovery
Do not delete the vault or job. If the key cannot be confirmed, stop and preserve the vault. Restore access may require the original exported key or the synology hyper backup vault password recorded at job creation. If neither is available, consult the service page before making changes:
